Search results

The JCB book says to refill the transmission it takes 17 litres. Either I am not getting all the old fluid out or the book is wrong, anyone else found this?

I have a Olympus plasma cutter with a Dinse DIX PX 101 torch. Does anyone know where I can buy the consumables for the torch? Any help much appreciated.

Hi would anyone know where I could find a brake shoe for this winch as photo, the other shoe is broken in half. The shoe is 12" from end to end.

Has anyone the workshop manual pages for the compensator valve and the hydraulic valve for the type with the three solenoids .(Just to be clear the valve blocks on the end of the hydraulic pump) The manual I have has just the type with the two solenoids. The hydraulic valve with three is quite...

Would anyone know where I could obtain the brake slave cylinder seals for the Hamworthy axle as fitted to the old dumper. The seals are ID 1,25" OD 1,75" I have as yet not been able to find any. Any help appreciated.

Does anyone know where I can obtain a new radiator for the International 454. Tractor Parts Co. have one that will fit but it has a much longer filler neck. Any help much appreciated.

Anyone any idea where I could find a new rubber coupling for the hydraulic pump drive on this old Manitou' It is a Ford 4000 underneath with a torque converter.

Does anyone know which make and model starter motor will fit an elderly two cylinder Lister Petter diesel as fitted in a three ton dumper?

The linkage is very very slow to lower. I have swapped top and bottom solenoids and valves to no avail. Power is at the lower solenoid in the front two positions on the hitch control. I don't know what the second different solenoid valve on the bottom of the hitch control valve is for, or...

Does any of you know where I can obtain a new accumulator for a Maxxuum, part No. 1530700C1, the accumulator in the powershift hydraulic line, with out costing an arm and a leg?

I hope one of the Maxuum experts may be able to help as I have just about given up. I will try to keep this as brief as possible. Crown wheel and pinion replaced + charge pump and main hydraulic pump + plus various solenoids etc. When cold powershift works normally, only the loader is slow to...