Hi all I have a case maxxum 140 in Witch won’t move .if it’s in low you just feel it start to bite then cut out I have error code 2037 clutch disconnected and 2047 clutch disconnect set to high and when I try to calibrate the trans I get u82 no 12v power to c3/c4 Also have no oil pressure...
I was rolling In my 8240 ford I was in gear high 2 then the drive stopped and gear box started to crunch now I can’t drive in high of low gears 1234
But it is fine in 5-8 in hi and low is there anything to you try be for I strip it a parts and have a look in side
im having a problem with my John Deere Sg2 2140 as soon as I turn the ignition on the Rev needle jumps to 500 rpm even with the engine turned off I have replace the magnetic sender in the front timing cover and it still dose it any thing else to look out for ? Many thanks joe
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.