Search results

Anybody got a Kuhn rw1610 wrapper? Any good?

Have one bitch pup left needing a new home from our litter of 5. Out of good working parents and been well handled by children 8 weeks old and ready to go sensibly priced, Shropshire/Welsh border

Bought a breeding ram at a sale last Saturday, looks like he’s got a urethral obstruction (calculi) not seen any hard feed since coming here just been on a little grass paddock, in my limited experience of this in fat lambs it’s never a good outcome. Question is should he be covered by the...

Anyone got front linkage to suit a Massey 3120 for sale?

Got a fella single rotor rake and a couple of the tine arm holders have some play in them, so thought I'd look at putting new bushes in, had hoped that after taking the 2 bolts out, the holder would pull out but no such luck, anyone know how it's done or is it a full strip down job? Thanks

Put a field of barley in for wholecrop early May, crows had bit of a go at it and have turned up quite a few stones, been to wet to get on to roll since, now it's drying out but it's about 6/7inchs high, will the barley pick up again after rolling at this stage, anyone experience of doing this?

How many miles do you tend to get out of a set of front brake pads? My cam am went for a service, only done 2k miles and dealer changed the front pads, just questioning if they would need changing so soon or is it a case of increasing the bill?

Question is square or round section steel? In my mind round is better but what are other peoples experience of square section grids with sheep?

Made some hay on some rough ground that had got ahead of the sheep and there is a little bracken in it, is there a potential problem from feeding it?

Was topping yesterday and as going along the tractor just locked up and stopped dead, started it, and it wouldn't move either way felt like the drive was locked solid, bit of trying it back and forth and it did release in reverse, made some horrid noises for a few yards then cleared and you...

How many bales are people getting out of 2 rolls of wrap on a 991 high speed, I'm only getting 57/58 doing 8 rotations, on an older 991 machine using the same wrap and following the same baler I'm getting 30/31 bales out of a roll at 16 rotations. Can see that there are 2 tails to every bale so...