Trying to get data off smart touch.
Can get maps and jobs on OK.
Jobs can be created and run but don't seem to export by USB.
The other issue we are having is section control settings seem to revert each time you stop the tractor.
Is it possible to get a task controller that replaces the quantron to change the spreader to iso bus.
Just got an iso screened tractor but it won't talk to the spreader.
Got VRA and section control unlocked.
Ideally I would like to still be able to use the spreader as it is.
We have used Revystar on Spring Barley at "paint brush" for ramularia and it is disappointing.
We used Adexar type (old stock) as a T2 on wheat and I thought we had too much septoria. My independent agronomist brought some plants from a neighbour who had used Revystar (same variety) and it was...
Considering a used tub mixer to replace a Keenan. We have moved to an auger bucket for most feeding but need to get baled silage into troughs.
How well do tub mixers work when they are loaded well below capacity?
We feed some high cereal diets that require a bit of roughage - straw and silage.
We have an old sumitomo SH60 (jcb JZ70). It is showing high water temperature after 10 minutes from start up. If I take the thermostat out it runs cool. Tried a new stat and it still overheats. There is not pressure in the radiator. I am running a flush in it to see if that helps. Any clues...
We have put a 30t perry conveyor in roof of a grain shed.
There are 2 slides that I would like to operate remotely, there is a rack that would need a pinion and chains. Could I use a pneumatic ram, air could come from a tractor or compressor plugged in at the door. The slides will not be...
Got a hi-tech T153 with a problem on the de clutch buttons.
When the button is pressed the clutch disenges, transmission display shows N but then the clutch does not re engage - got to restart the tractor. There is a button on both the gear and range levers and both have the same problem...
We are reusing a perry 30t conveyor in a new grain shed. It will hang from 3 rafters once in the shed
What is the best way to clamp brackets to the steel rafters.
Don't want to drill or weld.
We are keeping visits to an absolute minimum. However this week there have been 5 vehicles on the farm, 3 would not have been needed 20 years ago.
Essential ones = 1 lorry came for fat cattle (but only took 1/3 of planned), 1 came with 10t of fert (should have been delivered 4 weeks ago with the...
We are extending a grain store to end up with a 48m long shed 18m wide.
The height of under the ridge is just under 9m.
The shed is filled from a 22t continuous flow drier, realistic flow will not exceed 20t per hour.
How well would a belt conveyor work and any ideas of cost.
For 350Ha arable and suckler beef farm in the Scottish Borders.
The job will involve driving a modern combine, tractor and telehandler. Along with general maintenance and some stock work. Spraying experience would be useful.
Experience preferred but training can be given to the suitable...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.