Hello guys, i have NH t6050 2009 and it have this problem, when i press the clutch and go forward or backward no problem but when i go forward or backward without pressing clutch dashboard saying CP and dont moving it happens in every gear not only one, so what can be problem? Watch the video to...
Any ideas why the pto is slipping on high torque when using a topper 5 ft cut it has suddenly started. If lifted at no cut pto starts and gains speed then will continue.as the mower is lowered into cut and continues until repeated.
Also observed that hydraulic oil is contaminated with engine oil...
I have a N reg 18 speedshift 399 that’s lost drive.
When I bought the tractor there was two known faults with it:
1. Collapsed thrust bearing
2. Slipping in tortoise (low) on the speedshift
Even with these faults the tractor still drove as normal in hare with all gears and everything else...
Hi everyone, I have a John Deere 440 tractor with a 1070 loader, it is a manual tractor, the problem is it will go into gear but won't move/drive, does anybody know what the problem could be.
Seeking advice.
Purchased a brand new Iron Baltic Flail mower. I live in the UK. First time out in the field, mowed about 5-10 metres max, but grey smoke blew from the tensioner belt and it seemed the clutch had burned (black carbon flakes found inside the belt guard).
Clutch replaced by a...
Am i right in thinking there is no adjustment on the clutch and if my pedal is getting high the tractor needs breaking for a new clutch? Sob
If this is the case are there trolleys for wheeling a bigher tractor apart. Split a small tractor before using a trolley jack but my 3095 is bigger
Hi!
After having problems with my MF5465 Dyna-4 i found at the problem was related to the bottom-of-clutch switch (BOC). The faulty part had replacement 4374044M1, which combines both BOC and safety switch in one solid state switch.
However, after replacing the part, I became aware that the...
Hi,
I have ended up finding myself restoring an old Universal 550(pretty much a fiat 550). It was meant to be just new injectors and piston rings but I got dragged into replacing more as you do....Anyway...
I am replacing the dual clutch plates and bearing of the clutch and i noticed the...
helping a local farmer with an issue on their tractor
Intermintant fault where the tractor will not start , have got it to go by turning on the auto trans button.
I suspect it could be the pedal potentiometer , or the neutral switch in the gearbox.
Any body have any experience like this , or any...
Hi all,
I have a JCB 1135 and had a clutch that would jump. I've rekitted the master cylinder and replaced the slave cylinder but now when it builds up full air pressure the slave engages fully and wont release. The clutch pedal is solid. Only way to release it is to remove the air line and the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.