600m Front Umbilical Reeler Measurements Please

[agrifab]

Hi, tasked to build a front mounted umbilical reeler for 600m 5" pipe, I have rough measurements from a Storth catalogue but could do with some hard measurements! So if anybody can help with the following I would much appreciate:

• Reel diameter
• Width of inside the reel
• Hydraulic Motor used, specifically if it chain driven. Ideally the model/serial number off the plate to work out the displacement/size of motor
• Finally the number of teeth on the chain sprockets

Any help regarding any of the points would help massively!

Thanks

 

[jack6480]

Cheaper to buy a Tramspread bobbin reeler buddy

 

[Bobthebuilder]

If only @Speedstar wasn’t still out in his fendt trying to run out of diesel he’d be able to tell you [emoji849]

 

[agrifab]

No worries, not planning to start the project for a week or two!

 

[Blue.]

Hi, tasked to build a front mounted umbilical reeler for 600m 5" pipe, I have rough measurements from a Storth catalogue but could do with some hard measurements! So if anybody can help with the following I would much appreciate:

• Reel diameter
• Width of inside the reel
• Hydraulic Motor used, specifically if it chain driven. Ideally the model/serial number off the plate to work out the displacement/size of motor
• Finally the number of teeth on the chain sprockets

Any help regarding any of the points would help massively!

Thanks

I'll measure my Tramspread reel when I next go past it,don't bother with the storth measurements as they aren't big enough,well the one I had wasn't and I sent it back.

 

[Speedstar]

Hi, tasked to build a front mounted umbilical reeler for 600m 5" pipe, I have rough measurements from a Storth catalogue but could do with some hard measurements! So if anybody can help with the following I would much appreciate:

• Reel diameter
• Width of inside the reel
• Hydraulic Motor used, specifically if it chain driven. Ideally the model/serial number off the plate to work out the displacement/size of motor
• Finally the number of teeth on the chain sprockets

Any help regarding any of the points would help massively!

Thanks

You are wasting your time to build one with a chain drive to work with 5" hose unless you put 2 motors on it as one will never do the job , just buy a tramspread one , job done then

 

[jack6480]

You are wasting your time to build one with a chain drive to work with 5" hose unless you put 2 motors on it as one will never do the job , just buy a tramspread one , job done then

Learn from this man he made a reeler and now can’t get rid of it [emoji23][emoji23][emoji23] jokes