750A - 2630- mapping stop/start

[Louis Mc]

Running a 750a through a 2630 screen on non ISO bus tractor. Is it Possibe to make the coverage mapping switch on and off as drill goes in and out of work??

 

[Shropshire Farmer]

You need to have task controller switched on. It should then show auto on the implement screen.

 

[H.Jackson]

My 2630 is attached to a sprayer iso loom on the odd occasion it recognises the drill it thinks its a mounted planter with 8 rows. I have a switch onthe mettering wheel arm plugged into the loom for switching.

 

[Lukehaynes]

Set up a machine profile for the drill, put all the measurements in. Tell it what you are drilling. All can be done on the equipment tab on gs3 section of menu. You can choose what starts and stops mapping, ie spool 1 or link arms.

 

[Louis Mc]

Set up a machine profile for the drill, put all the measurements in. Tell it what you are drilling. All can be done on the equipment tab on gs3 section of menu. You can choose what starts and stops mapping, ie spool 1 or link arms.

Not on non ISO tractor with mechanical scvs though...

 

[Lukehaynes]

Not on non ISO tractor with mechanical scvs though...

My bad, didn’t think of that.

 

[AF Salers]

Surely you should be able to use the land wheel as the coverage on/off switch as you do for activating the seeding motor? Would just need setting up on the 2630 pages

 

[Louis Mc]

Surely you should be able to use the land wheel as the coverage on/off switch as you do for activating the seeding motor? Would just need setting up on the 2630 pages

Yeah that's what I'm thinking but just haven't managed it yet

 

[Brisel]

Did you get any further with this? A finger microswitch on the land wheel wired into the implement switch at the back of the tractor is how I've done this in the past. There should be a 2 wire plug coming out of the loom with the trailer light socket. If there's more than one, don't use the one with a bridge link cover. Rather than spend a fortune on a JD plug, I just cut the plug off & fitted spade connectors to the ends of the wires. It's just a simple on/off switch so don't go putting 12V down any wires or you'll have trouble with the Canbus system.

 

[Louis Mc]

Did you get any further with this? A finger microswitch on the land wheel wired into the implement switch at the back of the tractor is how I've done this in the past. There should be a 2 wire plug coming out of the loom with the trailer light socket. If there's more than one, don't use the one with a bridge link cover. Rather than spend a fortune on a JD plug, I just cut the plug off & fitted spade connectors to the ends of the wires. It's just a simple on/off switch so don't go putting 12V down any wires or you'll have trouble with the Canbus system.

Thanks @Brisel yes jd mechanic was in yard the other day and he said the same

 

[Feldspar]

Have our 750a running through a Topcon X30 screen. Back to old software version as new one was buggy, but we are now back to auto shutoff and switch on with half section control.