Atv sprayer tank swirl pot/ twin feed to the pump?

[Binc]

Looking for opinions/ options.. If I go on a slope with less than 15L the tank (depending on which way the slope is obviously) the pump won't pick up... bit annoying as the tank is 60L has anybody seen a tank with anything that would stop this?

I was thinking a twin feed; one to either side but can't think of a way to stop it drawing air from the top side [emoji21]

Any ideas welcome!!

 

[suffolksmallholder]

I look at either putting the tank on a gimbal or use twin pumps.
SS

 

[Clive]

pump tank to a small swirl pot - like a race car fuel tank setup to avoid surge

 

[Mursal]

Could you plumb a 20L can/tank under the big tank feed the pump from there?
Agitate/return back into the larger tank (as it probably is) for full mixing ...........
Manual tipping frame for the tank, leave the outlet at the bottom, but that will be determined by the slope.

 

[Mursal]

.

 

[ROBINWORKS]

C-Dax have tanks that fit to ATV's that will draw liquid from both sides of the wrap around tanks, and also lower the centre of gravity for working on slopes
http://www.c-dax.co.nz/index.php?pa...&parent_cats=e038a916542d4941a66addfc39823178
think I may have a s/h one available

 

[chickens and wheat]

mount the tank longways on draw bar and avoid going up and down?

 

[Mursal]

Or leave it where it is and only go up and down?

 

[Binc]

C-Dax have tanks that fit to ATV's that will draw liquid from both sides of the wrap around tanks, and also lower the centre of gravity for working on slopes
http://www.c-dax.co.nz/index.php?pa...&parent_cats=e038a916542d4941a66addfc39823178
think I may have a s/h one available

I remembers those but couldn't remember what make they were! Would you pm me a price and pics?

 

[Binc]

Or leave it where it is and only go up and down?

I like the idea, but I end up rarely managing to go just up or just down awkwardly!

 

[Binc]

Could you plumb a 20L can/tank under the big tank feed the pump from there?
Agitate/return back into the larger tank (as it probably is) for full mixing ...........
Manual tipping frame for the tank, leave the outlet at the bottom, but that will be determined by the slope.

That's a thought! I did muse with fitting a swirl pot to the inside but couldn't think how to do so!
I like that idea though! [emoji106]

 

[chickens and wheat]

easiest way would be a feed at each side each with a stop valve, fiddly but workable and simple