Calibrating clutch packs on maxxum 140

[foul mouth phil]

Just wondering if any of you helpful lot know the procedure to calibrate the clutch packs on an 09 plate maxxum 140? I know you have to warm the tractor up first,then switch it off, and start up again holding the up and down power shift buttons at the same time,which brings up CAL on the display,I can't remember what has to be done next.Its multi controller model with 4000 hrs on the clock,16 speed 40k.The clutch is very fearsome when pulling off,more so when the tractor is warm.

 

[mattydraw]

On a different note sorry but what do you think of the 140?

 

[tweedale terrier]

Have you changed the transmission oil and filters. This can make a big difference to power shift changes.

 

[foul mouth phil]

Have you changed the transmission oil and filters. This can make a big difference to power shift changes.

Yeh serviced just before Xmas.The power shift changes are jumpy, but the clutch control is brutal when trying to pull on to the road or hitch up to a trailer.

 

[foul mouth phil]

On a different note sorry but what do you think of the 140?

Been good up till now,pulls well, a bit loud and thirsty when its flat out.

 

[farmer jay how]

I've got 2008 140 maxxum with 3000 hours with 50k box, was four years old with 2000 hours when got it, was running 956xl 1997 two wheel drive and a 956xl 1990 FWD from new, before that, still got both 956xl.
140 maxxum is awesome...

 

[Oily rag]

Not 100% on case but try doing as you said and then set rpm to 1200, shuttle forward handbrake on and press and hold downshift. After each pack press upshift to get next one on to the screen? Let me know if it doesn't work.

 

[foul mouth phil]

Cheers for that I'll have another play tomorrow, don't want to fudge any other settings up.

 

[milton-95]

@robbie

 

[foul mouth phil]

Not 100% on case but try doing as you said and then set rpm to 1200, shuttle forward handbrake on and press and hold downshift. After each pack press upshift to get next one on to the screen? Let me know if it doesn't

 

[foul mouth phil]

Tried doing this earlier,don't think its quite right though,c27 shows in bottom display,there may be something else wrong.

 

[Oily rag]

I'm off with the kids today but il have a look later. It should be a u code if it's a problem. Ring me tomorrow when your with the tractor and il try and talk you through it. 07870513187.

 

[foul mouth phil]

I'm off with the kids today but il have a look later. It should be a u code if it's a problem. Ring me tomorrow when your with the tractor and il try and talk you through it. 07870513187.

Will do thanks.

 

[SamGuest_]

Hey did you guys end up working out how to do this correctly?
Thanks