Case 895 rear arms linkage

[Toylexus]

Hello all. Some implements are catching the rear wheels so I need to extend the rear arms. I can lift a lever and extend the rear arms but it's very flimsy. I'm I missing something here or is there another way round it.
Any advice greatly appreciated

 

[Bald n Grumpy]

Those aren't for extending the arms ,they're are to make it easier to attach implement and should be locked back in as soon as you've hooked up. If you put longer arms on it will cut lift capacity and possibly make tractor front light
Would look at adjusting/modifying implement

 

[Nearly]

Have you fitted bigger tyres or just new ones?

 

[Toylexus]

Tyres are 16.9r34. I havent changed them and about 50% worn. Here's the forklift attached.
I could take wheels of forklift.

 

[Nearly]

Tighten up the check chains to stop the forklift moving sideways. It is designed to run on the floor.

You could set the tractor wheels out wider.

 

[Flat 10]

Hello all. Some implements are catching the rear wheels so I need to extend the rear arms. I can lift a lever and extend the rear arms but it's very flimsy. I'm I missing something here or is there another way round it.
Any advice greatly appreciated

Nothing should catch the wheels

 

[essexpete]

I don't think you should use the arms in the extended position. The extending element is only to assist hitching up. Have you got oversize wheels/tyres fitted? Is the implement only catching tyres towards full lift?

 

[Classichay]

Adjust your check chains or your going to end up with a 500.00 bill for a new tyre. Don’t run with the extendo link out as it’s only a 14mm roll pin which will cut off and you will find the forklift through the fibreglass roof they were designed to help hitch onto implements, you reverse back and the top lug clunks back in to lock it again.

 

[essexpete]

I don't think you should use the arms in the extended position. The extending element is only to assist hitching up. Have you got oversize wheels/tyres fitted? Is the implement only catching tyres towards full lift?

Apologies I had not read an earlier reply or two. Set as it is it is never going to work. Is it just the forklift wheels that foul the tractor tyres?
I wonder if you could set the wheels of the tractor wider? Still potentially dangerous if a check chain broke.

 

[1594mac]

As said above tighten the check chains they look very loose so will be swinging about like crazy, I guess it has the same 3 or 4 holes near the axle side or at least an 885 does. I cant remember the positions off the top of my head. Depending on position is almost rigid in some cases.