Dowdeswell power Harrow

[Laggard]

Swapping some driven shafts of a donor machine. How am I going to knock back up the tab washers on the 60mm special but without have to take the power Harrow tray apart?

 

[Andy26]

You can surely just lever it with a large flat screwdriver or similar?

 

[Barleymow]

Pry bar, ransomes plough bar point, plasma cut big hole and re weld back on

 

[Laggard]

Pry bar, ransomes plough bar point, plasma cut big hole and re weld back on

Bit harsh the old plasma cutter

 

[Two Tone]

It’s not that difficult to take the tray lid right off if you have access to a good windy-gun or the battery powered equivalent. You will do the job properly if you do and probably solve a lot of other looming problems.

Make sure you use hard enough nuts and bolts where the linkage frame attaches to the bed as the have a nasty habit of stretching and coming loose if you use standard bolts.

 

[massey765]

It’s not that difficult to take the tray lid right off if you have access to a good windy-gun or the battery powered equivalent. You will do the job properly if you do and probably solve a lot of other looming problems.

Make sure you use hard enough nuts and bolts where the linkage frame attaches to the bed as the have a nasty habit of stretching and coming loose if you use standard bolts.

12.4 bolts