FORD 6600 RESTORATION

[David the spud man]

Its a 4600 but should be similar ......................
Keep a wee eye on him putting in a spacer 2:35 minutes in from the beginning.
The end of the shaft is then used to tap it on in .............


......................

The 6600 has a different type of spacer I side unfortunately

 

[David the spud man]

The best money youll spend right now is on a workshop manual. It will give you detailed instructions on how to fix everything.

What brand of manual

 

[David the spud man]

The brake pad is just spinning above the shaft

 

[David the spud man]

Somethings not right there!!! Is the locking plate still on the bolt head that holds the halfshaft in? The stub shaft usually rest against the plate. Seen them ‘lost’ during assembling and finding their way through the epicyclics when driving off resulting in burst trumpet housings!!!

Everything is in as it's shown in the parts breakdown

 

[David the spud man]

Does anyone know how many brake linnings and brake discs go in to it

 

[Mursal]

Did you misplace something that controls the position of the shaft?

 

[David the spud man]

Everyth8ng is there I checked the parts manual

 

[Mursal]

You will need to have another look.
The disk cluster may not be in the correct position sitting to far out in the trumpet or the retaining bolts are tightened up incorrectly.
Just take it down again and double check as you go.
Double check there isn't anything lying in the bottom of the trumpet housing.

 

[db9go]

Everyth8ng is there I checked the parts manual

 

[David the spud man]

Hi can anyone help when taking the half axle off to do the seal and brakes I was pulling all the old oil with my hand out and I found this pin in the oil

can anyone tell me where it came from 19 spanner for scale

 

[REStracTORATION]

View attachment 598154 Hi can anyone help when taking the half axle off to do the seal and brakes I was pulling all the old oil with my hand out and I found this pin in the oil

can anyone tell me where it came from 19 spanner for scale

Is one end sheared like as if it's been snapped

 

[Mur Huwcun]

Is one end sheared like as if it's been snapped

Half looks like the bar handle from a 1/4” drive T bar!!!

 

[db9go]

is it hollow like a tube as it looks like it has an o ring on one end

 

[David the spud man]

Is one end sheared like as if it's been snapped

No doesn't look like it has been snapped

 

[David the spud man]

is it hollow like a tube as it looks like it has an o ring on one end

it's not hollow it's a solid bar it has a slot like for a o ring or circlip

 

[Mursal]

It looks like a handle from a set of pullers we have.
But both ends have grooves, I think?
The groove just holds the fancy bit on the end.
I'll measure the size later ............