Grammer Seat head rest

[quavers]

Grammer seat head rest , how do get them off ? trying to fit a seat cover and it pulls right up but does not come out , any ideas

 

[Steevo]

Grammer seat head rest , how do get them off ? trying to fit a seat cover and it pulls right up but does not come out , any ideas

Press the little button in?

 

[quavers]

no button

 

[ACEngineering]

Grammer seat head rest , how do get them off ? trying to fit a seat cover and it pulls right up but does not come out , any ideas

pull it harder! push it down and pull up in one motion with force. thats how all the ones i have done work, got a big detent on them i think.

 

[ih1455xl]

Lift the round plastic cap off and under that is a r clip flick it out with a screw driver then will lift straight off

 

[kill]

pull it harder! push it down and pull up in one motion with force. thats how all the ones i have done work, got a big detent on them i think.

Same here

 

[quavers]

thanks will have alook again , was in a hurry last time and didnt take much time to have a proper look .

 

[ACEngineering]

Lift the round plastic cap off and under that is a r clip flick it out with a screw driver then will lift straight off

Never seen that but you could be right Never had a problem pulling them out so no reason to look IMO!

 

[ih1455xl]

Never seen that but you could be right Never had a problem pulling them out so no reason to look IMO!

Only remembered as did one yesterday when fitting nice new GRANIT seat cover

 

[ih1455xl]

 

[quavers]

it was clips under the plastic caps as ih1455xl suggested , thanks for your replies

 

[Grouse]

Only remembered as did one yesterday when fitting nice new GRANIT seat cover

can I ask what that cost and where from please ?

 

[quavers]

It was a Granit seat cover that i have fitted , the bottom seat and back rest are in to different parts , the bottom seat is held on with 2 velcro straps , each time i go in the tractor after somebody i have to refit the bottom cover , not a good seat cover .

 

[ih1455xl]

It was a Granit seat cover that i have fitted , the bottom seat and back rest are in to different parts , the bottom seat is held on with 2 velcro straps , each time i go in the tractor after somebody i have to refit the bottom cover , not a good seat cover .

They normally fit really well I take the bottom cushion off and fit it on properly

 

[quavers]

They normally fit really well I take the bottom cushion off and fit it on properly

will try that , the fit of the covers is good , just the bottom cover keep coming off , was thinking of putting a stitch in where the velcro is to hold it .

 

[ih1455xl]

will try that , the fit of the covers is good , just the bottom cover keep coming off , was thinking of putting a stitch in where the velcro is to hold it .

There’s 4 torques screws 2 at the front and 1 either side half way back