Jcb 310 pivot bushen

[it's not over]

Has anyone changed this bushen. Any pics. Once the drop box is out does the bush go in from inside or outside. I think I can do this with out undoing all hyd pipes???. Told it's a 2k job. Weve rebushed a matbo before. It's on standby for feeding so no big rush on completing the job

 

[davidroberts30]

not done it but ive heard its not a massive job
drop box off and undo the pin
iirc the bushes are in 2 halves
just hope the pin isnt worn

 

[Fendt820]

Need to do a 320 at some point. Got bad lately.

 

[ACEngineering]

Old TM's you had to push the 2 halfs apart completely.

 

[davidroberts30]

Old TM's you had to push the 2 halfs apart completely.

These are the same

 

[ACEngineering]

These are the same

Will have to split it in 2 then, as i recall from reading the service book as you push it apart the front has to come up slightly too?

I would think it'll not be an easy job as a first timer and on farm? i think i priced parts for a TM300 years ago and was over £1k just in bushes? so £2k to do the whole job sounds about right?

 

[davidroberts30]

Will have to split it in 2 then, as i recall from reading the service book as you push it apart the front has to come up slightly too?

I would think it'll not be an easy job as a first timer and on farm? i think i priced parts for a TM300 years ago and was over £1k just in bushes? so £2k to do the whole job sounds about right?

And hope the pin isn't worn

 

[Fendt820]

I would think the pins are worn as I always find on our JcbS the bushes and harder then the pin.

 

[it's not over]

Is this the bush

 

[davidroberts30]

 

[Timbo]

I would think the pins are worn as I always find on our JcbS the bushes and harder then the pin.

Agreed - the knuckle pin is usually worn as well as the bushes.

There was an article in the FW regards 2nd hand TM's and to be aware of the cost to do the joint when it needs doing.

 

[Fendt820]

Agreed - the knuckle pin is usually worn as well as the bushes.

There was an article in the FW regards 2nd hand TM's and to be aware of the cost to do the joint when it needs doing.

I remember reading it and was sure the cost was 3/5k