Steven5140
Member
Hi All,
Currently rebuilding a shuttle reverser for a JCB telehandler. Its the really early one with cable controls rather than solenoids. I've just installed the forward clutch plates into the gear housing but the top cir clip which holds all the plates in doesn't seem to sit in the groove very well. The groove is actually really shallow. If i press on the clutch plates from the bottom hard enough the clip pops out. Is this normal?
Thanks
Currently rebuilding a shuttle reverser for a JCB telehandler. Its the really early one with cable controls rather than solenoids. I've just installed the forward clutch plates into the gear housing but the top cir clip which holds all the plates in doesn't seem to sit in the groove very well. The groove is actually really shallow. If i press on the clutch plates from the bottom hard enough the clip pops out. Is this normal?
Thanks