John deere 2650 splitting for clutch

[Tomr10]

Anybody know how many bolts are in the bell housing on a 2650. Clutch has gone thanks

Maybe @Phil P ?

 

[Tractortech]

Now Then..
There are 6. 2 at the top, access from the rear side, 2 half way down though one is technically a stud with a nut, then 2 underneath that pass through the engine sump, access from the front side..
There's other stuff to undo and/or remove too.
Is this an SG2 or MC1/CC2 tractor?
The bigger looking holes in this parts picture are where to look.

 

[Tomr10]

Sg2 ?

 

[Tractortech]

Low profile SG2, possibly/probably with gear levers in the floor??
There's an auxiliary fuel tank to contend with too. And remove the MFWD shaft, check and replace the sealing bush while it's off.
It's a good idea to replace the release bearing assembly in the clutch housing as they fail when you don't want it to,,,,

 

[Tomr10]

Low profile SG2, possibly/probably with gear levers in the floor??
There's an auxiliary fuel tank to contend with too. And remove the MFWD shaft, check and replace the sealing bush while it's off.
It's a good idea to replace the release bearing assembly in the clutch housing as they fail when you don't want it to,,,,

Yer gears I n the floor 3rd time clutch been done over many years of hard work. Forgotten were they all are . I'm guess the new topper is a bit much for her to start up and helped cause it this time

 

[Tractortech]

The topper will be driven by the PTO clutch and not the traction clutch. They are completely separate and in different locations. It's a different split for each.
Which clutch has actually failed/is slipping??

 

[Tomr10]

Main clutch

 

[startinghandle]

Is there oil leaking onto clutch?
Free play on pedal?
does driver rest foot on pedal?
Also is radiator core and fan blade clean as excessive heat is not good
for clutch

 

[startinghandle]

Where are you getting new clutch from?

 

[Tomr10]

Where are you getting new clutch from?

Not sure yet.