paul&mandy
Member
- Location
- surrey/west sussex
Paul
John deere 6930 pto circlip broken
- Thread starter paul&mandy
- Start date
Paul
Pebd99
Member
- Location
- Aberdeenshire
Little flat screwdrivers wedged in then a bit of brute force yank it out or keep breaking it to bits and you'll be fine.
paul&mandy
Member
- Location
- surrey/west sussex
Yes you could do that with the old 10 and 20 series.... this bloody thing on the other hand...
- Location
- Herefordshire uk
Had it happen on my 6150 last month had dealer do it he got a little screwdriver behind that tab and using a punch and hammer hit the tab round until the circlip came out if u see what I mean need to have the engine running to stop the pro turning
- Location
- South West
Good pair of mole grips and pull the tab outwards and turn anti clockwise until it over the ledge of the PTO stub shaft and just keep turning anti clockwise until circlip falls out.
Well that would be my line of attack
Well that would be my line of attack
Last edited:
- Location
- Sth Africa
Use a set of pliers and gas torch with a small welding tip- heat and pull the clip out gently as you pull it. It'll stop in places but just reheat and go again.
paul&mandy
Member
- Location
- surrey/west sussex
Thanks I'll give it another go.
Tractortech
Member
- Location
- Cumbria
I'd try this one too, but beware of the seal!! It wouldn't be a big or expensive job to replace it anyway
paul&mandy
Member
- Location
- surrey/west sussex
Not had a chance yet but knowing my heavy handed-ness how would you remove the circlip if the tab was broken?
- Location
- Sth Africa
You dont!!!!. Becareful and use the gas and make the steel pull out and spin it out when you pull on the remains of the clip out when its hot. It takes about 3 mins to do the job.
You'd then convert all your implement shaft yokes to 6 spline so you didn't need to turn the tractor stub