John Deere rtk

[fidds]

Anyone got a way around using rtk curve at below 0.6k ?

 

[alomy75]

Assume it’s in a plumbed in system rather than an ATU? I had similar issues in the past trying to go slowly and never really resolved them. I bet if you go into tech mode there will be a minimum value somewhere but where and to what it needs to be set I don’t know. If it’s kicking out at different speeds roundabout your 0.6k rather than dead on 0.6 you might try reducing the sensitivity? It might be trying to do too much and as you’re going so slow it thinks it’s not achieving it’s target (?)