least disturbance: simba ld vs sumo gls

[phil-i-am]

Making a reasonably light duty sub-soiler for headland conditioning pre direct drilling. Which legs would give me the least disturbance, simba ld or sumo gls?

 

[moldengineer]

Would say the gls would give you less disturbance. If you put a disc in front of the leg then disturbance would be reduced even more.

 

[Andrew]

We use a Sumo GLS for putting OSR in.

 

[Northdowns Martin]

We use a Sumo GLS for putting OSR in.

View attachment 284630View attachment 284634View attachment 284636View attachment 284638

Andrew where and how do you place/drop the seed?

 

[Andrew]

Just drop them about 6" behind the leg. Made them clamp round the leg. Had to cut the end of the tube at an angle to stop it blocking though. had to move he packer to the rear most hole too.

 

[Will 1594]

What thickness are those legs

 

[clodshopper]

Havent seen gls point like that before, are they genuine Sumo?

 

[Andrew]

Havent seen gls point like that before, are they genuine Sumo?

Yeah. Couldn't tell you any details, but definitely in the parts book.

 

[Andrew]

What thickness are those legs

20mm

 

[Will 1594]

Our low disturbance legs are 12 mill with front cutting disc by time packer has been over you cannot see where it's been till you stick spade in

 

[Andrew]

Our low disturbance legs are 12 mill with front cutting disc by time packer has been over you cannot see where it's been till you stick spade in

Would imagine they bend rather easily though

 

[Will 1594]

Would imagine they bend rather easily though

Did just over 400 acre mix of limestone and heavy Carr land They are all still square. And would be down to bed rock 10 /12 inch and 12/14 on heavy Come and look at them and the results. You will bend them if you go round corners with them in ground

 

[Andrew]

You will bend them if you go round corners with them in ground

That's what I meant. Snaky headlands and some of the drivers round here..... I'm amazed they haven't bent ours yet.

 

[clodshopper]

who makes the 12mm legs?

 

[Will 1594]

who makes the 12mm legs?

Twb. Terry birch. 07966233104