Manitou safe load indicator

[bazza3034]

no you wont measure volts on that other plug.

Hi ace could you supply me with the trackrod end knuckle on the manitou 728 i the treads have been stripped on the knuck that screws on to the ram could get me 1

 

[ACEngineering]

Hi ace could you supply me with the trackrod end knuckle on the manitou 728 i the treads have been stripped on the knuck that screws on to the ram could get me 1

No problem. Send you a PM

 

[rob762]

Hi,

I have the similar problem with a 627 MLT. It’s an 08 plate and the load sensor keeps beeping all the time regardless of load. It shows a red and a green light. Is this a calibration problem? If so how can it be done?

 

[rob762]

This is what it looks like

 

[ACEngineering]

This is what it looks like

Ah that wire
Ignore it it's not used.
Plug them plugs apart a few times to make sure contacts are clean cause that can send the lights round the bend sometimes

 

[rob762]

Tried that but no luck just flashes these lights and beeps too