Matbro manual

[willcaseboy]

Anyone have a workshop manual for 290 hi torque ?

 

[holwellcourtfarm]

@ACEngineering ?

I know Great Exportations sell copies of most Matbro workshop manuals.

 

[willcaseboy]

Ok,cheers

 

[ACEngineering]

View attachment 381718 Anyone have a workshop manual for 290 hi torque ?

What would you like to know?

Edit Tis a fine looking workshop you got there

 

[willcaseboy]

After complete wiring diagram,lube chart etc.....she needs a bit of work!

Thanks,always something doing in a farm workshop

 

[ACEngineering]

After complete wiring diagram,lube chart etc.....she needs a bit of work!

Thanks,always something doing in a farm workshop

Cant help with a wiring diagram but one is not really needed to be honest as they are quite simple electrics just get stuck in.
If you have a very rare model with powershift and or danfoss electric joystick then its a little more complicated. But most of these machines were just standard 4 speed mechanical box with shuttle and mechanical joysticks.
A few relays and things under dash, mice like to chew the wiring under dash and I think its the back of the fuse box wiring loom that can rub on the gearstick lever and cause issues. I certainly had a customers like that and I seem to remember taking the stick out and adding a bet of a bend to it so it cleared a bit more?
Anything that's really bugging you about the wiring just ask. These suffer from poor starter motors and are best replaced with a Iskra gear reduction one which is higher powered.

Oils

Engine not too fussy on oil. They are happy with a old or new spec 15/w40, I just use 15/40 E7 as it does some of the newer stuff as well bit over spec for older engine like yours but not too over spec to cause any issues.
Transmission ATF Dextron 2
Axles Limited slip 90 front and rear.
Wheel hubs EP80-90 gear oil or limited slip 90 same as axles.
Hydraulics HV46 or EP 46

 

[willcaseboy]

Thanks,it's a 1998 model so not too highly specked and rare in NZ so this is good info to start on wiring and servicing,very much appreciated

 

[ACEngineering]

Thanks,it's a 1998 model so not too highly specked and rare in NZ so this is good info to start on wiring and servicing,very much appreciated

TS290 hi torque are fairly rare machines anyway! Theres a few about but they were only built for about 6 months or so then matbro went bust.