Hi guys. I have a M115. My lift arms will not work from inside the cab but will operate no problem with the mudguard switches. I have a fault code 24 and than appears code 27. Any ideas? Thanks!
Fault code 24 is perform hydraulic lift calibration. Fault code 27 is Lift Arm Position Sensing Control Voltage Low (Short Or Open Circuit). Hope this helps.
Fault code 24 is perform hydraulic lift calibration. Fault code 27 is Lift Arm Position Sensing Control Voltage Low (Short Or Open Circuit). Hope this helps.
Can U tell me how to calibrate hydraulic lift?
My TM is being naughty, it loses it's calibration for no apparent reason. So far it's had a new potentiometer, a new EDC panel and the dealer has been over it. Any clues where to look? No error codes showing but it won't operate at all inside the cab, but can operate with the fender buttons...
So we have a slight problem. We started today to calibrate the linkage on our TM150. The reason was that she was only lifting to 97% and we couldn't get the hitch to go down. We done the following. Key off Unplug the wire from that pot Key on for a few seconds Key off and plug the wire back in...
Location: Village Hotel Bury, Rochdale Road, Bury, BL9 7BQ
The Farming Forum has teamed up with the award winning hardware manufacturer Easy Compute to bring you an educational talk about how AI and blockchain technology is helping farmers to diversify their land.
Over the past 7 years, Easy Compute have been working with farmers, agricultural businesses, and renewable energy farms all across the UK to help turn leftover space into mini data centres. With...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.