Plowman Omni-Lift

[db9go]

Do any one use these Omni-Lift flat lift

 

[db9go]

Do any one use these Omni-Lift flat lift

 

[mo!]

There are a few round here, but we are very local to the factory. Very well finished bits of kit.

 

[snipe]

Looks identical to a Tim Howard maxi lift

 

[hutchy143211]

We run one of their omni-tils, fantastic bits of kit and brilliantly engineered. They use the metcalfe NG leg system which is a low disturbance tungsten carbide leg that can be configured however you want. We run 250mm wings which I think are the same as the ones I the picture above and the give a very good amount of lift/fracturing but don't sap power due to the narrow leg and shin profile. If you want to go more low disturbance you can go down to 150mm wings.

 

[JP1]

We run one of their omni-tils, fantastic bits of kit and brilliantly engineered. They use the metcalfe NG leg system which is a low disturbance tungsten carbide leg that can be configured however you want. We run 250mm wings which I think are the same as the ones I the picture above and the give a very good amount of lift/fracturing but don't sap power due to the narrow leg and shin profile. If you want to go more low disturbance you can go down to 150mm wings.

The quality of the welds always impressed me