should snap on swap a bent 3/4 strong bar

[roscoe erf]

we have bent our 3/4 bar
did it undoing some wagon wheel nuts that some idoit had had a bar on, we did not have a bar on our strong bar, its about 4ft so shouldn't need it!

made my knuckles really rattle when it "cracked" snap on man says they wont swap it as its not "broken"

just wondered if anyone else has had this?

they swap 1/2 inch bar ends no problem, they don't take that much doing.

never ever put a bar on!

Short answer no they won’t but once it broke they will been there got the tee shirt

 

[Exfarmer]

Only a snap on user would still be using a bar, the rest of us save our money for a nutrunner which does the job in seconds and does not give you a bad back.

 

[ACEngineering]

Only a snap on user would still be using a bar, the rest of us save our money for a nutrunner which does the job in seconds and does not give you a bad back.

some have both, but my backs still bad

 

[A1an]

If you have managed to bent that bar unaided (no exttension pole) then it’s an inferior bar imo.

 

[dannewhouse]

Only a snap on user would still be using a bar, the rest of us save our money for a nutrunner which does the job in seconds and does not give you a bad back.

have nut runner but no where near compressor, I haven't enough wind to run it!

 

[Hilly]

Yes they will (even though technicaly they are not obliged to)

I've done something similar with a 3/4" Snap-on bar in the past and THIS is what you may the premium for ................ if your man won't I would tell him its the last thing you will buy from them as there are plenty equally as good tools these days much cheaper but without the no quibble warranty they built their premium brand upon

The premium price is built in finance not the warranty, if you can afford tools dont buy snapon if you cant buy snapon for the fiver a week.