Made a stand what ours sits on ,with loader brackets on it ,move it around easily,and lift it up to wash underneath better ,
Hi oli, our spreader and I think the KRM both sit a little further back. We offer hydro drive but very rarely sell it as our discs run at a fixed speed all the time. A lot of manufactures offer and sell hydro drive as they vary the speed of their discs to alter spread patttern. We merely adjust the drop point on the disc ( a sulky patent until recently) to adjust our pattern
Wouldn't you still be between the spreader and tractor attaching the hydraulic pipes?
+1 if you go look at fert spreaders 20years old the kuhns will be in the best condition
I always back upto spreader get it all right to hook on then pull forward a foot if PTO is long enough then connect PTO, hydraulic pipes etc then finally hook spreader on that way it doesn’t matter how awkward it is!
You must be using hydraulic top links I guess
The only people who don’t use a hydraulic top link are those that haven’t experienced one!
Does what it says on the tin
Which one do you use? How long min and max? How much pulling force?
I use these from Spaldings on my 6520/6630, I bought them on an offer probably 5/6 years ago with the appropriate ends. Think they where just under £300 all in at the time but looks like they’ve gone up quite a bit since then (what hasn’t!). Actually bought one liked it that much ordered another.
Thats made me smile phil ,bought a box full of stuff outbof cheffins and in the bottom was 3 ofvthose top links , 2 needed hoses , and one needed thread tidying ,up as end had un wound and damaged last 2 turns , hydraulic place squared up thread , all three where less than 1 new one
