Roy_H
Member
Been there done thatView attachment 849298
This old lube bottle screwed perfectly into the filler cap hole
Been there done thatView attachment 849298
This old lube bottle screwed perfectly into the filler cap hole
It enables the pick-up hitch on the loader to be rotated 90 degrees so as to stop it digging in the ground.What is that strange arrangement on the hitch with the pin and ?thumbscrews
What is that strange arrangement on the hitch with the pin and ?thumbscrews
Fed up with forgetting to unplug the trailer light electrics on my hay and straw trailer, therefore snapping the cable, I have come up with the solution of using 3 (12v) snap connectors that will snap apart the next time I forget again!
This will prevent me having to rejoin the wires again with a screw type block connector.
View attachment 853481
View attachment 853479
View attachment 853480
The idea is that the cable closest to the plug has 3 staggered snap-plugs, so as not to try them all apart at once.
As the trailer doesn’t have fog or reversing light, I can eliminate the blue wire and only need 6 of the 7 wires, hence only needing 3 pairs of double snap plugs.
Brakes? What brakes?What happens to the brake line...??
BUT, dropping the bucket or grab doesn't put the brake lights on.Brakes? What brakes?
I’m pleading the 5th.
Ok, It’s a fair cop!
But at least the trailer brake lights will work to show that I am braking or at least attempting to slow down.
(If the worst comes to the worst, I’ll switch the hazard lights on too!)
Problem, hitching up the old Vicon, as it sits so close to the back of the tractors.
Solution, make it into a trailed sower.
I think this qualifies on two counts for this thread, as it is a bodge, and secondly all materials are second hand, never to mention the "new" PTO guard.
View attachment 853696View attachment 853698View attachment 853699
Another slight problem to overcome.Can you reach the open close leaver out the back window now ?
Another slight problem to overcome.
It does have that sticker. It’s the yellow one at the top.It should have a ‘tighten with hammer’ symbol sticker on it!