Yes the alternator is brand new . No the lift doesn't work the gears doesn't work or the rev counter doesn't work. Just wondering if it was a pressure switch where would it be on the tractorAre you sure the alternator is good? Does electronic lift work? Check and double check all connections including earths to ETCU. Video looks like voltage /pressure switch/ wiring issues to me unless the ETCU has thrown a wobbly.
Whats battery voltage engine running?Yes the alternator is brand new . No the lift doesn't work the gears doesn't work or the rev counter doesn't work. Just wondering if it was a pressure switch where would it be on the tractor
12.5v from battery before I start. 14.2v when engine startsWhats battery voltage engine running?
Thank you I will try that and let you know how i get onWhat year is the 6270.
As mentioned check the wiring and plugs going into the auto3 under the r/h step.
The yellow feed wire is prone to corrode.
Check the resistance of the engine speed sensor as well before you start the tractor
It located in the centre of the r/h hydraulic side plate
The resistance needs to be in the region of 470 ohms
Year is 00Thank you I will try that and let you know how i get on
Year is 00
Yeah it looks like you are.Am I missing a pin in this? If so would I require a new ECU or could I get it repaired
Am I missing a pin in this? If so would I require a new ECU or could I get it repaired
That doesn't make sense based on this.
"Massey 6270 starts fine but will not move and the rev counter doesn't work. After around half HR running the BCD light will slowly come on on the dash after a further 10mins the rev counter will start working and the tractor will move again . What could be the issue"