Search results

Ok thanks for your help👍

Ok, thanks for your help, with regards to my other post is it likely I’ll have issues running two beacons off the other two tractors similar to this issue?

Thanks, is that a plug in and go job then?

I’ve read through some posts on here about the switch failing on these tractors if you run two beacons off them. The solutions is to wire in a relay, could anyone shed any light on what sort of relay to wire in?

The switch failing seems to be a common problem reading through here. I think solution is to wire a relay into the system as there is not relay as standard

Yes, I was just worried about the power required for two beacons as my 6050 has two beacons and this melted the pins in the back of the switch panel.

I have bought beacons for my two tractors and I am wondering if I will be ok running two beacons off the original wiring and plugs in the cab? Thanks

Does anyone know the modern equivalent of these types of gear oil, it’s for a new Holland 376 small baler?

Does anyone know where I could get a feeder crank arm for a new Holland 376 small baler?

I haven’t had any problems so far (6000) hours

I have read a few threads about packer tines in a 376 and from what I can see you need to have the curved/adjustable ones to eliminate banana bales. My question is whether or not you need all the tines to be curved or just the leading two?

It must be worse in a t6 because I wouldn’t say my 2010 6050 is that bad

Why is the whine such a problem?

thanks 👍

Could you use a 1.55 metre cb Ariel for fm radio?

Just got it fixed. Thanks for all the help and advice.

It appears I didn’t look very carefully the first time?

Just realised that the shaft is slipping and all that’s missing is a little grub screw to hold it in place.?

No definitely not