If memory serves me right held in place by a circling the agitator piece should just pull of but the bearing part that’s left on the shaft might need to be cut with small angle grinder carefully hope this helps
I think there is a company in Barnstaple Braham and Murray good hemp that extract oil from the seed but I don’t think they do anything with the straw they grow it themselves
Be careful of the disc variety we had one that would move a lot of soil to the middle especially if tempted to go too fast , this would then take longer to come through and the slugs would run this area
anybody got any ideas of how to get a leg back into position after shear bolt breaks usually come back to the yard and deal with it with the handler , loathed to grease it as dust sticks and makes it worse . Sometimes can just reverse with the plough down but more often gone to far for the tip...
I haven’t really pushed it as I prefer to make a good solid bale slowly, l think it’s 4 ft 6 but not sure the auto net is activated when the bale gets to a certain size and the buzzer goes of in the cab to stop but can drive on for another five or so seconds until you see the net going into the...
Get to know the control box well , a camera on the wrapping table is a godsend. Did some hay first just to get to know the baler the next day wrapped haylage pretty simple when you get to know it. Obviously a lot of chains and bearings that need lubrication and if they haven’t wear pretty...
the aux spool not working all the time and to get it to work have to feather the up and down and it’s gettng to be bit of a pain with the straw spreader any ideas tia
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.