Northern farmer
Member
- Location
- North
Any idea why Amatron+ struggles with speed signal? Worked fine when first tested with a new tractor (Amatron+ plus GPS Switch, UF01 sprayer). After a while speed signal coming intermittently, then lost. Picking up speed signal from the tractor implement connector (gear box speed).
Speed signal seems to be wired from the tractor to the sprayer box (at the sprayer), connectivity fine from the implement socket to the connector where the sprayer cable comes to. Need to test with the old tractor but the tractor speed signal seems OK, only measured with a MM, laptop attached scope is a bit clumsy but should check with that too.
Amatron+ works fine with the sprayer box for everything else. The speed info from the sprayer box must be coming via CAN, suggests an issue between the tractor socket and the control box at the sprayer but it is almost a direct wire, just one big connector on the way.
Anybody experienced something similar? Suggestions for further checking?
Speed signal seems to be wired from the tractor to the sprayer box (at the sprayer), connectivity fine from the implement socket to the connector where the sprayer cable comes to. Need to test with the old tractor but the tractor speed signal seems OK, only measured with a MM, laptop attached scope is a bit clumsy but should check with that too.
Amatron+ works fine with the sprayer box for everything else. The speed info from the sprayer box must be coming via CAN, suggests an issue between the tractor socket and the control box at the sprayer but it is almost a direct wire, just one big connector on the way.
Anybody experienced something similar? Suggestions for further checking?
