Fusion netter problem

[hally]

Strange one today but when netting a bale, the knife would drop in and instead of stopping turning the rubber roller still carried on turning and reeling net into the chamber so the door wouldn’t open and the net was to cut manually. Haven’t come across this before and probably just an electrical fault ( been around all connectors with wd40) but can anybody shed some light on this issue as some busy days coming up.
checked the net knife sensor and it is ok and lubed the nylon shims on the knife and all the other moving parts of the netter.

 

[H200GT]

Had similar on fusion 2, net not cutting. It was down a failed gas strut to that tensions the net on the right hand side of the baler. Knife wouldn't cut net as not enough tension to hold it taught

 

[icanshootwell]

Strange one today but when netting a bale, the knife would drop in and instead of stopping turning the rubber roller still carried on turning and reeling net into the chamber so the door wouldn’t open and the net was to cut manually. Haven’t come across this before and probably just an electrical fault ( been around all connectors with wd40) but can anybody shed some light on this issue as some busy days coming up.
checked the net knife sensor and it is ok and lubed the nylon shims on the knife and all the other moving parts of the netter.

I've had a similar issue when the baler hit a bump in the field, caused the net to run, speeding up on headlands can cause problems if field is rough also.

 

[Cmoran]

As above change the gas strut and it will be perfect again the struts on the side panels are the same so you can swop it out and keep going

 

[hally]

Seems to be fine now after changing that strut so thanks for the help

 

[SamN]

Was the net knife dropping in all the way to cut the net? The knife bushes can get a bit sticky and stop the knife from tripping