Intelliview4 section control

Nitrams

Member
Location
Cornwall
Trying to get the section control up and running thru isobus terminal to operate bogballe spreader. Have entered activation code successfully but the spreader and map arnt communicating. I think I should have a task controller and section control tab at the bott of the toolbox but its not there. Any ideas anyone? The spreader is operating thru the isobus terminal ok.
 

davidnh

Member
Location
Northern Ireland
what version is the intelliview on? If you have unlocked it was task controller installed beforehand? You will also need the display setup wizard installed to setup the section control to work
 

Nitrams

Member
Location
Cornwall
what version is the intelliview on? If you have unlocked it was task controller installed beforehand? You will also need the display setup wizard installed to setup the section control to work
Not sure what version the software is, but took it to dealer to make sure it had the updated software for it. It didnt have a TC installed bedore the unlock.
 

Nitrams

Member
Location
Cornwall
If it’s not showing it there you will need your local dealer to install it and the setups wizard for task controller to work
Ok thanks. Shame they didnt do that when I took it into them. They dont seem to know much about it, which I can understand as they dont have much call for it but the NH backup seems nonexistant. Im sure they will get back to me when all the fert is spread🙄.
Thanks for your help though, I will approach them again
 

Will you help clear snow?

  • yes

    Votes: 70 32.0%
  • no

    Votes: 149 68.0%

The London Palladium event “BPR Seminar”

  • 14,730
  • 232
This is our next step following the London rally 🚜

BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth

Join us @LondonPalladium on the 16th for beginning of UK business fight back👍

Back
Top