Trying to get the section control up and running thru isobus terminal to operate bogballe spreader. Have entered activation code successfully but the spreader and map arnt communicating. I think I should have a task controller and section control tab at the bott of the toolbox but its not there. Any ideas anyone? The spreader is operating thru the isobus terminal ok.
Intelliview4 section control
- Thread starter Nitrams
- Start date
davidnh
Member
- Location
- Northern Ireland
what version is the intelliview on? If you have unlocked it was task controller installed beforehand? You will also need the display setup wizard installed to setup the section control to work
Not sure what version the software is, but took it to dealer to make sure it had the updated software for it. It didnt have a TC installed bedore the unlock.
davidnh
Member
- Location
- Northern Ireland
Once it was installed does it work now?
No there is no TC tab or SC tab
davidnh
Member
- Location
- Northern Ireland
If you go to to toolbox —> TC is it set to installed? On the wizards tab as well does it show TC wizard beside the cal tab?
No those tabs dont exist in toolbox or wizards
davidnh
Member
- Location
- Northern Ireland
Under diagnostics —>version does it show task controller and the version installed there?
Pretty sure not. Not with the tractor atm to confirm that but fairly sure ive looked most places and not found it anywhere
davidnh
Member
- Location
- Northern Ireland
If it’s not showing it there you will need your local dealer to install it and the setups wizard for task controller to work
Ok thanks. Shame they didnt do that when I took it into them. They dont seem to know much about it, which I can understand as they dont have much call for it but the NH backup seems nonexistant. Im sure they will get back to me when all the fert is spread
.Thanks for your help though, I will approach them again