Kuhn 40.1 fert spinner

[tr250]

My spreader was about 7 out on the scale at one side to get it to empty even. I just adjusted the scale as it is slotted so both sides read the same. Perhaps not technically correct but its enough to keep my minor ocd issues in check!

Your supposed to do that with a cat 2 pin in the hole shut it down tight on the pin them move scale to 85

 

[tr250]

@Broomy could you have left the headland boundary spread setting down 5% or whatever by accident?

 

[indiescot]

Your supposed to do that with a cat 2 pin in the hole shut it down tight on the pin them move scale to 85

Im just slowly turning into my father and didn't bother with the pin! Not used this year yet but will try the pin when i set it up. Have done it before but it was annoying me as it had been properly checked and tray tested the previous season.

 

[tr250]

Im just slowly turning into my father and didn't bother with the pin! Not used this year yet but will try the pin when i set it up. Have done it before but it was annoying me as it had been properly checked and tray tested the previous season.

Ha

 

[Broomy]

Ours is same.
How do you check agitatiors in Bottom of hopper safely

I set it running at tick over and then reached in with a fence post and put a bit of pressure on each one. Not sure if you class that as safe !

 

[Broomy]

@Broomy could you have left the headland boundary spread setting down 5% or whatever by accident?

No. I don’t adjust the settings when doing the headlands

 

[simon-0116]

I set it running at tick over and then reached in with a fence post and put a bit of pressure on each one. Not sure if you class that as safe !

Should it keep turning or stop

 

[Broomy]

Should it keep turning or stop

Not sure. Mine slow down if you put a pressure on them. Both sides were the same so I thought they were ok

 

[Sprayer 1]

The last time i used my spreader i noticed that the slider on one side was shutting slightly, so i had to keep pushing the leaver . Not investigated yet so not sure if its the ram or my tractor spool letting oil through.