Try to succeed
Member
Hi,
Currently having an issue with my spreader and wondered if anyone could suggest anything. Started using it the other day and the weight reading shot up over 3000 when I’d only put 1200kg in. As a result the flow factor bounced back and forth so I emptied it on manual setting. Have done factory reset and calibrated a few times. It holds on zero for a while then starts bouncing up and down in the hundreds again above and below zero. Is there anything I can do or does this sound like I need to spend on new weigh cells? I can’t see any issues with wiring.
Thanks
Currently having an issue with my spreader and wondered if anyone could suggest anything. Started using it the other day and the weight reading shot up over 3000 when I’d only put 1200kg in. As a result the flow factor bounced back and forth so I emptied it on manual setting. Have done factory reset and calibrated a few times. It holds on zero for a while then starts bouncing up and down in the hundreds again above and below zero. Is there anything I can do or does this sound like I need to spend on new weigh cells? I can’t see any issues with wiring.
Thanks