Kverneland geospread

[KB6930]

I've been spreading at 24m since I got it what's involved with going to a wider spread for the section control side of it just a case of changing the width same as the spreader?

 

[Al R]

@Battlefield Machinery

 

[Badshot]

Surely if you've told it it's now, for instance, 48 m, it's still 12 sections, but 4m instead of two meter.

 

[KB6930]

That's what I'm thinking will happen but not 100 percent sure. It's mor like I'd go to 36 for grass so it's not like I'm doubling the size of sections is why I'm wondering

 

[KB6930]

Answered my own question it sorts itself out when you set up a fert for a wider setting

 

[Badshot]

Answered my own question it sorts itself out when you set up a fert for a wider setting

Thought it would.

 

[Battlefield Machinery]

What control screen are you using? The spreader will work in 1m increments but it depends what the controlling screen can do, if it’s a Tellus on old software it’s 24...but will always but bigger sections in the centre of the machine...newer software has 36 or 48 sections, or a JD will have well over your width requirement.... the spreader will need to be on software 1.19 or later and if it’s a JD screen make sure it’s not 1.21...it doesn’t connect to JD isobus reliably....

 

[KB6930]

It's the big tellus working in 2m sections . Did the job yesterday and it all worked fine at 32 m

 

[Battlefield Machinery]

Ah tidy,

 

[KB6930]

I'd have gone wider but lift vanes were required and I've not got them

 

[Battlefield Machinery]

Ah they will be, a heavier product you Dan sometimes get to 36...but it’s touch and go and your inclination becomes very critical!