I have been having some trouble with my splendimo 320 mower when puting it together. when I tighten the big nut on the end it is very hard to turn. could that because the axle is a little twisted? I also bought one new drive element and it is relly weird to turn it. it almost raddles is that normal?
lely splendimo 320
- Thread starter Hreinn2001
- Start date
- Location
- N.Lincs
Did you clean the threads/run the nut on before you put the last unit on??
Did it turn ok before you assembled it??
Pistonbroke
Member
Do you mean the nut is hard to turn,or the mower bed? If the hex shaft has a twist or bend it causes loads of trouble
I meen the mower bed
It came assembeld
- Location
- N.Lincs
Yeah, but before you assembled the unit on the bed, was it hard to turn then??
Just trying to establish it it's the new unit that's causing the drag or all the old units and drive shaft.
Yes it is hard to turn it before I put it on the table. I had to take the bed apart becous one axle broke there for only 4 of 7 discs turned. And it was easy to turn them. Its only when i tighten the bed together that it starts to becomes hard to turn.
- Location
- South shropshire
Lely Splendimow......” the work of the devil himself” 
The London Palladium event “BPR Seminar”
This is our next step following the London rally 
BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth
Join us @LondonPalladium on the 16th for beginning of UK business fight back
lwtheatres.co.uk
BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth
Join us @LondonPalladium on the 16th for beginning of UK business fight back
BPR Summit | LW Theatres
lwtheatres.co.uk