Looking for signal

[Swedeboy]

We have a JD6930 with a 2630 screen and now need to get a signal to open the slide on a grass seeder. The seeder is on a rotavator that’s on the linkage arms. So when we lower the linkage arms the gps starts to paint and a signal is to be sent to open the slide on the seeder. How can we get this signal?

 

[Timbo]

We have a JD6930 with a 2630 screen and now need to get a signal to open the slide on a grass seeder. The seeder is on a rotavator that’s on the linkage arms. So when we lower the linkage arms the gps starts to paint and a signal is to be sent to open the slide on the seeder. How can we get this signal?

You'll need the basic section control

 

[Swedeboy]

Thank you!
We shall see if the little man in green knows about this.

 

[Zebbedee]

Can you not get a signal from the iso socket ( small socket maybe 9 pins in it) should be a lift up down signal among others in there to do your job probably need to put it through a relay if any sort of power required

 

[e3120]

Or a finger switch on the top link. No need to involve the GPS.