Manitou 737 won’t start

[Rogersabine]

Hi my 737 cut out after 20 minutes of use and an error code came up 00-7ff19.02 and now won’t start not even turn over. Does anyone have any ideas

 

[e3120]

You've nothing to loose by turning the battery isolator off for a minute. I sometimes think they fitted it in such a handy position for a reason. We did have a fault where the engine on our 635 would cut out after the screen failed to boot properly, and the old faithful reset was the only solution.

 

[BK741]

If you turn the ign on lift the bonnet can you hear the electric lift pump priming? Needs 3bar to start. Could also be low fuel pressure switch failed. Silly but has it got fuel in the tank?

 

[Rogersabine]

If you turn the ign on lift the bonnet can you hear the electric lift pump priming? Needs 3bar to start. Could also be low fuel pressure switch failed. Silly but has it got fuel in the tank?

You were right there wasn’t any fuel in there, it’s a faulty fuel gauge as was showing half full

 

[BK741]

Might be a sticking float on the tank sender

 

[ACEngineering]

You were right there wasn’t any fuel in there, it’s a faulty fuel gauge as was showing half full

Give the tank a wack with a bit of 4x2 and tell it not to do it again?

 

[dlhss]

Hi my 737 cut out after 20 minutes of use and an error code came up 00-7ff19.02 and now won’t start not even turn over. Does anyone have any ideas

 

[dlhss]

Hi my 737 cut out after 20 minutes of use and an error code came up 00-7ff19.02 and now won’t start not even turn over. Does anyone have any ideas

Does anyone have error codes list like this one? etc. 00-01CB7.00

 

[Anton adi wicaksono]

I ask for a solution to overcome this problem

 

[vantage]

I ask for a solution to overcome this problem

Cover it with black silage tape!

 

[Anton adi wicaksono]

Cover it with black silage tape!

what is covered with black silage tape?