MCconnel Hedge-Cutter VFR/Easy Cut

[James]

If your dealer can't sort it ring Alex Perry at mcconnel

 

[scottishsnake]

If your dealer can't sort it ring Alex Perry at mcconnel

Thanks

 

[FMF74]

Hi folks, just got my new 6570vfr machine home this week.... Chuffed with it so far, but the EDS doesn't seem to put enough lift on the arm, even on the soft setting, the head is running so hard on the ground that it drags the arm back all the time. I do see some pressure settings in the EDS menu, but there's a password in front of me, and I'm not even sure getting the code would let me change the pressures.... Anyone got any experience with this?

Our trimmers need to mate!
Mine lifts right up as soon as I engage EDS

 

[scottishsnake]

Our trimmers need to mate!
Mine lifts right up as soon as I engage EDS

That's even less handy than mine lol. There must be a way to get in to set the default pressure in the lift ram

 

[FMF74]

Mine is under warranty and they are meant to be coming out next week. I will let you know what they say

 

[scottishsnake]

Mine is under warranty and they are meant to be coming out next week. I will let you know what they say

That would be magic, thanks very much

 

[FMF74]

That would be magic, thanks very much

Turns out mine had a faulty pressure sensor on the bottom of the lift ram. The engineer seemed to think they all need setting up slightly differently but wasn’t keen to let on how

 

[scottishsnake]

Turns out mine had a faulty pressure sensor on the bottom of the lift ram. The engineer seemed to think they all need setting up slightly differently but wasn’t keen to let on how

No, that's the impression I'm getting.... Be nice to just get into the menu behind the passcode and have a furtle