Meal Mixer and old Roller Mill

Discussion in 'General For Sale - £350 and under' started by steveR, Feb 24, 2019.

  1. I have been clearing out some old machinery next to the now redundant grain bins and drying setup, dating from the early 60s!

    I have removed an old Alvan Blanch mixer and an even older roller mill from the building and wondered if there is any demand for it? Both have 3ph electric motors that were working when we last used the machines, around 2005!

    Drop me a line if they are of interest. Also got a hammer mill with an 8cwt (I think) hopper to come out sometime, that was refurbed and has a more modern motor as I recall and not done much work after being installed.
     
  2. Bob c

    Bob c Member

    Location:
    Cotswolds
    looking for a mixer
    only got single phase :(
     
  3. New motor?? ;)
     
  4. Bob c

    Bob c Member

    Location:
    Cotswolds
    could do
    but been there all ready,...and was costley
     
  5. Have you any pics of mixer please ,
     
  6. Do you do Whats app? If so, PM me your mobile and I'll squirt some pics over.(y)
     
  7. Andyfeed

    Andyfeed Member

    Location:
    Surrey, UK
    Are you still looking we have one for sale single phase located Surrey
     
  8. Bob c

    Bob c Member

    Location:
    Cotswolds
    i am
    may re-sheet the one i have ,..a winter project

    what have you got and price
     
  9. Andyfeed

    Andyfeed Member

    Location:
    Surrey, UK
    1C556CC6-BDF4-4FBA-98A0-86719B64548F.jpeg
    B72B30D4-9535-4279-885F-FF9142BDBA25.jpeg Ok it’s a bit older then even I thought it’s been here for 50years but works fine just been disconnected as we are knocking the building down £150 pounds not really been used for 15 years prehaps once every other month but it does work
     

    Attached Files:

    Bob c likes this.
  10. Bob c

    Bob c Member

    Location:
    Cotswolds
    any holes in the bottom where it touches the ground on the other end ?
     
  11. Andyfeed

    Andyfeed Member

    Location:
    Surrey, UK
    Don’t think so I will pull it out next week and have a look I did the final mix with it last week and it seemed fine but I will get a better look then
     

Share This Page