And don't tell the dealer?Trade it in
1/2" isn't going to affect the drivetrain of the bed. Keep checking the oil regularly. If it starts to show any hint of glitter in it then so using it.Got a Pottinger mower bed which is bowing up in the middle by around 1/2 an inch what would be the best way to go about straighten this ?
And hope the dealer is blind.And don't tell the dealer?
Thanks it runs smooth still hence why I want to straighten this I’d had a mess about with a bottle jack but didn’t have much luck more than likely wasn’t going far enough with it just wondered if there was a better way to do it1/2" isn't going to affect the drivetrain of the bed. Keep checking the oil regularly. If it starts to show any hint of glitter in it then so using it.
best way to straighten is a piece of timber over top of bed and a bottle Jack onto chassis above
Push it straight with something heavy firstAnd don't tell the dealer?
Leave it overnight I've done kuhn beds in the past like thatThanks it runs smooth still hence why I want to straighten this I’d had a mess about with a bottle jack but didn’t have much luck more than likely wasn’t going far enough with it just wondered if there was a better way to do it
You can see it when’s on concrete there middle skids arnt touching the floor by 1/2 an inch or moreHow did you even notice it had bowed that amount? They probably flex as much while working
It'll probably pull down flat when it's working, especially in a heavy crop.You can see it when’s on concrete there middle skids arnt touching the floor by 1/2 an inch or more