8100
Member
- Location
- South Cheshire
The one we had the 814 super had a rocker switch on the right hand side that made it rev higher for tracking etcMines a 1990 super one of the last but not seen that switch?
The one we had the 814 super had a rocker switch on the right hand side that made it rev higher for tracking etcMines a 1990 super one of the last but not seen that switch?
Next time to have buckets made I’d suggest going deeper rather then wider machine will handle it a lot betterView attachment 854944
We had a bucket built out of Hardox by Cherry Products. Very well built but also lightweight. We have got an old bulk handling bucket we used to use before we bought this one which we no longer need if it’s of any use to anyone (just requires some welding on the bottom)
Was it for coming out of a deep hole. It was a button you pressed if i remember right.The one we had the 814 super had a rocker switch on the right hand side that made it rev higher for tracking etc
Yeah it has but it sounds sore on the engine and looks like a steam train climbing a brae.Has it not got the boost feature on a rocker switch or is that just on the 814s .
There is a rocker switch on the dash that could switch on auto idle and also open up the top engine rpm when tracking selected.Mines a 1990 super one of the last but not seen that switch?
Yea got that but it doesn’t Rev when you track only if you pull a leverThere is a rocker switch on the dash that could switch on auto idle and also open up the top engine rpm when tracking selected.
3 position switch but perhaps it is not working. The auto idle bit does not work on ours.Yea got that but it doesn’t Rev when you track only if you pull a lever
Next time to have buckets made I’d suggest going deeper rather then wider machine will handle it a lot better