New Holland Tm Load Sensing Setup

[diyfarmer]

Hi All,

Hoping someone can help me. I have a New Holland Tm 165 with Power Command that I'm attaching a fusion 1 baler too.
The tractor already has a loader.

My understanding is that 3 in the picture is the return, 2 is the feed and 1 is the load sensing..

My Questions
1. Are my above assumptions correct?
2. Can I T into lines 1 and 2, leaving the loader connected?
3. Should the loader be disconnected?

Thanks much! in advance for any help...

 

[diyfarmer]

Hi All,

Hoping someone can help me. I have a New Holland Tm 165 with Power Command that I'm attaching a fusion 1 baler too.
The tractor already has a loader.

My understanding is that 3 in the picture is the return, 2 is the feed and 1 is the load sensing..

My Questions
1. Are my above assumptions correct?
2. Can I T into lines 1 and 2, leaving the loader connected?
3. Should the loader be disconnected?

Thanks much! in advance for any help...

 

[del_boy]

Have you got a manual for it, it should say in there .
Something tells me if you add an extra load sensing if you've already got a loader you will need to add a shuttle valve in the line somewhere.

 

[diyfarmer]

I have the workshop and owners manual, neither have any detail on the three ports, unless I missed it...

 

[del_boy]

I have the workshop and owners manual, neither have any detail on the three ports, unless I missed it...

It should be in one of them manuals id say.
There was some confusion on the earlier t7's where the manual suggested the ls pipe went wasn't right