- Location
- South West
I believe it may chop your grass alot better thoThat Giga vitesse looks like it may suit, getting bigger again though?
I believe it may chop your grass alot better thoThat Giga vitesse looks like it may suit, getting bigger again though?
Have you tried Hunter Kane in Co Antrim. They would sell quite a few or Riddell s near Maghera they are Strautman agents.
Emyr Evans have a 4510 like new
Wasn't sure if there was any strautmann dealers nearby, would that strautmann in cornthwaites be any better than a pottinger given it hasn't got CFS?
The strautmann at cornthwaites has CFS. Also has auto lube and been a farmer only machine.I think it is a CFS.
The crop flow roller is to lift crop off the camless pickup reel.
Knives are at 40 mm centres. (pottinger at 34mm I think)
I run a 3101 without CFS.
Acorn
the rotors in those ones are prone to imploding are they not? strautmann rotors are solid in thicker steel and the fingers are welded all the way around, probably about 5 times stronger.View attachment 497476 Here is one in Suirway might be a bit older but is in great condition
Most of the damage to rotors is caused by a broken knife going up and wedging against the rotor it then acts lake a lathe and cuts the rotor , the strautman rotor wears out quicker and needs building up with weld between the fingers , I know of a 3601 that wore it's rotor through quick enough , I've done one in the torro but it wasn't worn out , it was cut with a knife .the rotors in those ones are prone to imploding are they not? strautmann rotors are solid in thicker steel and the fingers are welded all the way around, probably about 5 times stronger.
the fingers are dropped into slots cut in to the rotor, cracks spread from one slot to the next until it snaps or implodes. what do you mean by wore its rotor through?Most of the damage to rotors is caused by a broken knife going up and wedging against the rotor it then acts lake a lathe and cuts the rotor , the strautman rotor wears out quicker and needs building up with weld between the fingers , I know of a 3601 that wore it's rotor through quick enough , I've done one in the torro but it wasn't worn out , it was cut with a knife .
I think it is a CFS.
The crop flow roller is to lift crop off the camless pickup reel.
Knives are at 40 mm centres. (pottinger at 34mm I think)
I run a 3101 without CFS.
Acorn
The strautmann at cornthwaites has CFS. Also has auto lube and been a farmer only machine.
You will work it no problem , the more power the mower output , but I've often had a 130 hp tractor on the torro 5100 and it got away , you just wouldn't pack as much of a load in , keep the knives sharp and it will save a lot of power , that wagon is good value , just check the rotor for any damage .@mtx.jag Have found a Torro 4500 not far away from me in Northern Ireland, would a torro be a lot harder to drive than a europrofi? Tractor available is 145hp Massey 6615 with no CCLS so would have to have a spool pumping too, would it be able for it? Wouldn't want it to be on its knees, would rather the tractor was well capable