Vicon vari-spreader 1001

[Wales584]

Hi all,
Does anyone know the correct bolt size or part number or correct name for the 3 bolts that connect the pto and rubber coupling to the machine it's an vicon vari-spreader 1001

 

[Cowabunga]

Can’t help you with the bolt size, which should be obvious if you are that intimate with the parts. There’s nothing special to the bolts as far as I remember.
Is this the one ton square steel hopper model of old Vicon? If so, I had one in the late 1970’s and am amazed that there are any still in service.

 

[Wales584]

Yes the steel hopper on it, it's been un-used for around 20 years but under cover and only half a pto it looks well enough tho

 

[Boohoo]

As far as I know the same rubber donut is used to drive the hydraulic pump on a David Brown 1390, it uses ⅜unc x 2¼ bolts. Shouldn't be that difficult to measure a few bolts though.

 

[David1968]

This any use to you?

Pardon our interruption...

 

[Nearly]

@Dave W likes doughnuts