Gapples's latest activity
-
Norbar always a good choice, but what’s probably more important than initially torquing wheels is to re check after a short period of use. -
Yes it can be done in situ. The correct way is to use a liner puller which consists of a round dolly that is a perfect fit into the...
-
Hi, I got the banjo bolts out and there was filters on them, drained the tank what I could, cleaned the filters and put back it situ, so...
-
Gapples replied to the thread The IH / Case Thread.Yes the liners will put out, you may have to make a puller to do the job. IF you are very lucky and using a piece of hard wood, you can...
-
To do it perfectly should do it with the engine running. There is a transfer pump in the front gearbox to pump it to the back housing...
-
Gapples replied to the thread High speed gear for hydraulic pump case 885.Why not just replace like for like ? Do you actually need the extra flow ? IF you fit the high speed gear to an earlier tractor you will...
-
Gapples reacted to Andy Nash's post in the thread High speed gear for hydraulic pump case 885 with
Like.
I would start by putting a pressure gauge on a remote and see if you’ve got at least 2200 psi and ideally a flow meter as well, so you... -
Pretty sure Rishi is going to adopt Liz Trusses policies over time. If so I applaud him...
-
Its starting to filter through to the political and media class that it is not going to happen. The targets of any sort are going to be...
-
the mechanic is probably still paying for it. :(
-
We had a valtra on demo and ended up keeping it. Only when I looked in the toolbox a month later, found a Snap-on changeable one left by...
-
China is definitely not the future
-
Gapples replied to the thread TM 150 2002.That would That would make sense, I always worked on IH/CaseIH kit personally Anyway we sold quite a few MXM 155s and others, I was...
-
Black chassis one coincided with the merger with CaseIH iirc. which ended up with Basildon churning out a bit too much for Quality...
-
Gapples replied to the thread Workshop Compressor..Another shout for Shiremoor compressors, they've been around a very long time now and will give you good advice...