Wondering if a water pump would work as a volume washer, for washing my cattle handling pens and yards down. I've got a old molex tanker, I'm planning to bolt it on. Asked local spot that sells them, and I couldn't make him understand I didn't want a pressure washer 🤦🏻♂️ could put a electric...
On pricing a new tanker with Doda pump for umbilical system. What are the pros/cons of having the vacuum pump hydraulic driven on the side of the tanker and the umbilical PTO driven ? rather than having a Garda gearbox driving the two. Slurrykat aren't keen of hydraulic vacuum pump, but Abbey...
Got a round baler and I'm wanting to narrow it in a bit, it's currently 9'6" wide and I'm catching the walls at both sides of the road going to my biggest customers. Now I can turn the wheels round, and due to the offset make it 7 1/2" narrower. The stud holes have a chamfer on one side where...
On trying to unsieze the linkage drop rods on my old Deutz, got one side done but the others refuses to budge. Can I heat the cast bit up to get it moving, or will it crack. I know there's a roll pin stopping it screwing right out, but I need it turning to knock that out. I've had it soaking in...
Not sure if this is in the right place but....
I have a customer owes me a substantial amount of money, I'm insured to pursue debt. Just had a email off my insurer's appointed solicitors to say they're going to take my case. At the top it says limit of indemnity £250,000 don't suppose this means...
How do I remove slack adjusters without knackering them, brake rod is seized solid at the brake end and I'd like it all to bits to clean it down, planning on putting grease nipples on, like the commercial ones have
On point of ordering a new trailer, blacks a no cost option. Just wondering if anyone's got one and regretted it, thinking about seeing trailer against roof when tipped, and how about keeping them clean ?
Where is the best spot to get some decent axle stands, haven't measured lately but think I'm looking 700-750mm extended height. Main job for swapping wheels round on my fasty
I'm after a couple of sets of wheels, they're goliath 350. I've tried to ring them in Ireland to find who my local stockist is, but can't get an answer. Looked online to no avail, anyone know who would sell them in Cumbria or where I could find them online thanks
Wondering how much ad blue others are using, my 4220 has used 210 litres to do 284 hrs. A good mix of work not just heavy work, average fuel consumption us 12litres hr
Anyone on here able to give me a price (or point me in direction of someone that can) for some drive over weigh pads. Sell a fair bit of crop off farm, been using my mates but got to stage where I'm using them more than him
Looking at some claas reverse drive mowers. Is it possible to split them and turn the rears round ? So I can run them front and back, if so how big a job is it. Also they're 9.4m so would 235hp be plenty to drive them.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.