Kuhn 5m power harrow

[MrMaxxum]

Evening all

Might seem a stupid question so bear with me but does anyone that owns a Kuhn HR 5003/5004 know it’s actual working width? As in could you put a tape across it next time you’re using it please?
In the brochure the overall width of all the power harrows is approx 8-20cm wider than the actual working width but the 5m is only 4.97m overalls width?? Either a typo or makes no sense

The kuhns normally run one rotor per 30cm and the 5m runs 16 so…..480cm

Reason I’m asking we’re thinking a 4.8m power harrow (24m tramlines) could work

Thanks in advance

 

[Ducati899]

I can check tomorrow,I’ve a 5 meter folding

 

[Alistair Nelson]

A 5m will happily drill at 4.8m seen plenty. The total width of the tube on a 4m packer is 3950, 2950mm for a 3m etc etc. As a guide

 

[goodevans]

Pretty certain our 5m fills all the gaps on 5m steering

 

[Lofty1984]

I’ve ours set on 4,8 m to match pass to pass

 

[MrMaxxum]

Thanks for all the responses

If you could check, that would be very helpful

Thanks again

 

[Ted]

Definitely can't have a wider working width than the overall width.
Operators manual reckons 4.944 mt working width, we allow 4.8mtr.

 

[Bomber101]

We have it set at 4.84m in the GPS.

 

[Ducati899]

Just measured my folding one and it’s working width is 4.85 meter

 

[MrMaxxum]

@Ducati899 that’s great, thanks for doing that we should be safe to set a combi up around that for 24m now

Wonder if you can get a refund from Kuhn for the missing 0.15m

 

[cosmagedon]

Our 5m runs around 4.95 on the GPS and it matches up nicely. I do narrow it down if I'm on any steep bits and I notice I'm sliding more though.