MF 6120 Clutch issues

[Aero_999]

Hi all

I Have a clutch on my 6120 that wont disengage properly.

This one is springloaded, it drives ok but gears are hard to get in.


I have a movie when pressing the clutch
but I cant upload it here.

Any tip would be nice.

 

[daveydiesel1]

Hi all

I Have a clutch on my 6120 that wont disengage properly.

This one is springloaded, it drives ok but gears are hard to get in.


I have a movie when pressing the clutch
but I cant upload it here.

Any tip would be nice.

Possibly the bottom of clutch switch is playing up

 

[Aero_999]

Here is the movie

20240217_102019_1.mp4

Visit this link to download: 20240217_102019_1.mp4

files.fm

 

[Aero_999]

This is when the tractor is turned off.

 

[masseybreaker]

it could be the lining off one of the drive plates has come loose and is inbetween two of the plates so it doesnt release properly . the only way to check is strip the clutch unit

 

[Aero_999]

Hi

The clutch is changed a few years ago, hasent worked properly since then.

New discs and alot of other parts.

 

[MF CI]

Hi

The clutch is changed a few years ago, hasent worked properly since then.

New discs and alot of other parts.

Ah, not worked right since last done. The only one I had to sort was the same. Found a plate or disc (?) had dropped and was causing clutch drag.
My thought was it had been assembled in situ, on the shaft. I took the whole thing out turned it vertical and built it up that way. No parts needed worked like new.
But do check the easy outside things first.

 

[Aero_999]

Is there anyone that have the info of converting these tractors to manuell forward and reverse?

 

[masseybreaker]

you need a gearstick and a side cover and the fork that fits on the selector rail and a few hydraulic pipes on the bigger 6100 you can make a 3080 side cover fit but on the small ones like yours the clutch valve gets in the way. it can be done but there is a bit more work
dont ask they are very hard to find a kit

 

[Aero_999]

I have that one on the tractor right now

Just wounder about the Electronic parts, dyna wont work when valves aint there.

 

[masseybreaker]

can you post a photo of the side cover you have on the tractor ?

 

[Aero_999]

Ja absolut.

It comes from a 6140

 

[masseybreaker]

on the first photo there is a blanking plug at the bottom of the side plate you need to fit the temperature sensor and plug that spare connector to it then everything might work

 

[Aero_999]

Så här ser de gamla delarna ut.

This one has the bosch sensor.

 

[masseybreaker]

the sensor in the center at the bottom of the side plate in photo 2 needs fitting to your other side plate . it senses the temperature of the oil if the oil is cold it stoppes the dynashift working

 

[Aero_999]

Hi

I mounted the tempsensor and now the dyna symbols are working but the tractor does not change the gears.

Im not sure about the hydraulic hose, see pictures.

 

[masseybreaker]

the hose needs connecting to the top fitting in the side cover that has the blanking plug on and then fit the blanking plug to the t piece at bottom it should work then

 

[Aero_999]

Moving the hose did work.

However the powersteering stops working out of the blue and suddenly it start working again .

Any ideas?